Shandong zhangqiu yi tai machinery manufacturing co., LTD
Contact: xin-sheng cheng
The true: 0531-83209474
WeChat ID: 13705411652
Q Q: 2458379166
Mail box: 6411111111 @163.com
Web site: www.zqlcfj.com
Company address: Shandong zhangqiu MingShui hou home park street
Fan gear is made of 20 crmnti after carburizing treatment, grinding, precision up to 5, tooth surface is more wear-resisting. Bearing imported bearing capacity big double row roller bearings. Improving the service life of the fan. Clean air blower output. Fan adopts special structure design, to avoid the oil substances into the chassis, so the output air does not contain any oil. All fan products, including accessories, has realized the standardization design and production, good interchangeability and commonality, satisfy the purpose of high quality, low cost, mass production. Safe operation of the blower and the service life, depends on the correct and preventive maintenance and regularly, talent and should pay attention to any accident, in addition to pay attention to the general maintenance procedures, all point should focus on the following:
1. Check whether the fastening of each part and the positioning pin is loose phenomenon, if there are any loose shall be fastened.
2. The fan inside the presence of oil leakage phenomenon.
3. The fan inside the scale, rust and spalling phenomena cannot exist.
4. Pay attention to oil cooling condition is normal, pay attention to the quality of the lubricating oil, often listen to the fan running with and without the noise, pay attention to the unit is in the work under the conditions do not conform to the regulations.
Overload of the blower are sometimes not displayed immediately, so attention should be paid to the exhaust pressure, bearing temperature, and the change of the motor current, to determine whether the machine running normally.
6. Remove the machine to machine each dimension measurement, recorded, and marking on parts and direction, so as to guarantee the assembly and can keep the original requirements.
7. The new machine or the blower after overhaul, according to the steps in operation, suggest 8 hours to replace the whole lubricating oil.
8. Under normal conditions require the unit running 1000 hours of lubricating oil must be replaced and no oil change in time of after-sales service is beyond the scope of free warranty.
9. Daily maintenance is very important, small fault must be repaired before put into use.
- three leaves roots blowers zhangqiu yi tai machinery manufacturing co., LTD. Is a professional manufacturer of roots blower ZLSR company. Its main products are roots blower, roots blower, and three leaves roots blowers three-blade roots blower, high pressure blower, ZLSR, three leaves roots blowers ZLSR fan is my company to design, development, production of a highly efficient, energy saving, environmental protection and new products. This wind turbine parts adopt numerical control machining center for processing, and has advanced detection equipment and high-quality personnel, to ensure that each factory equipment and have high quality, high service life. The company to provide you with perfect pre-sales consulting and after-sale tracking service, for every customer to remove trouble back at home, the new and old customers get the praise. My company is located in the east of jinan MingShui, jinan-qingdao road north, 18 kilometers away from jiqing expressway, jiaoji railway traverses MingShui city, traffic is very convenient. Welcome all customers to visit my company guidance, business negotiations. Telephone: 13705411652